Glitter Silver DI-212

Metallic and Glitter Plastisol Ink

Metallic and Glitter plastisol inks are bright, have excellent opacity, and are press-ready. These plastisol inks are ideal for either manual or automatic press applications.

Finish: Bright metallic semi-gloss

Opacity: Excellent

Drying: 320°F

Always pretest to determine suitability and curing parameters

Notes: A convection, forced-air dryer is recommended (minimum 10-foot heat chamber) because metallic and glitter inks are reflective by design. If an infrared (IR) oven is used instead, take special care to check for a proper cure. Abrasion during normal wash cycles may cause some dulling. Soaking in phosphate-free soaps (e.g., Woolite) is recommended to maintain metallic and glitter brilliance.

Fabrics: All types. For maximum coverage, use 61 to 86 monofilament for metallics and 17 to 61 for glitter inks.

Stencils: All types

Wash-Up: Use Thinner DT or any conventional plastisol wash-up system

Reducers/Thickeners: Use only if absolutely necessary. Modifications will reduce metallic brilliance. Reducer/Thinner DT will reduce tackiness and viscosity and minimize “ink hang” in the screen (1%–3% by weight). Reducer/Thinner PL will increase gloss and film elongation and improve “ink flow,” but it reduces opacity and slightly increases dry/cure time (1%–5% by weight; use with caution). Thickener Paste stirs in easily, slightly increases viscosity and dry/cure time (1%–5% by weight). Thickener Powder increases viscosity without affecting dry/cure time but requires stirring with a drill mixer (up to 1% by weight).

Storage: Store in a relatively cool area. Keep away from extreme heat and direct sun exposure. Store below 95°F.

Stir plastisols prior to each use. Do not dry clean or use bleach.

Always pretest before use to establish suitability and procedures prior to production.

Colors displayed on monitors may vary, so do not use them for exact matching.