Dual-Tack Pallet & Platen Adhesive Tape

Save Money and Keep Your Shop Clean With Dual-Tack Pallet & Platen Adhesive Tape

This Dual-Tack Pallet Tape is perfect for screen printing platens, direct-to-garment (DTG) printing pallets, and shirt boards. It is sticky on both sides to hold the shirt, hoodie or other garment in place without having to apply water-based glue or spray adhesive. It is a double sided tape for your platen! This saves you money and keeps your shop cleaner.

The adhesive can be re-activated by wiping with a wet sponge and putting under your flash spot dryer. If you notice the tackiness is wearing off; take a spray bottle with water and spray the adhesive. Use a flat brush, or sponge to wipe off t-shirt or hoodie lint. After you have wiped it clean, run the platen under a flash cure unit to reactivate the adhesive.

This double sided platen tape comes in two sizes - 15" inches wide x 36 yards, 18" inches wide x 36 yards.

Instructions

1. Stretch the tape across the platen or pallet.
2. Cut the tape to the size of your platen. Its best to cut it a little long so you do not cut your pallet itself.
3. Use a squeegee to smooth out the tape onto the pallet and get rid of any air pockets. Excessive air bubbles reduce the longevity of the tape.
4. Once the tape is in place, peel back the top protective sheet to expose the adhesive. If you notice an air pocket, use a sharp knife, box cutter, or X-Acto to poke a hole in and press down to smooth out.

 Now you are ready to print!